Guide · England compliance

Social housing electrical safety checks after the November 2026 deadline

England’s deadline for older social housing tenancies required checks before 1 November 2026. Use this guide to close missing checks, manage unsafe findings and keep resident communications on time.

Illustration of a home consumer unit with a row of circuit breakers, an inspection report with ticked rows, a separate appliance record on a clipboard, a phone with a resident’s message and a photo of a socket, and a wall calendar with a passed date marked by a small orange dot

For covered social housing tenancies in England granted before 1 December 2025, electrical installations and landlord-provided electrical equipment had to be inspected or checked before 1 November 2026, under regulation 3E. Installation inspections must then take place at intervals of no more than five years, or sooner if the report requires, and existing tenants must receive the installation report within 28 days of the inspection, under regulation 3.

Kreedl is our product. The rules and product descriptions in this guide were checked against public primary sources on 8 November 2026.

What matters now? TL;DR

The inspection deadline has passed. The immediate task is to reconcile missing checks, unresolved findings, resident communications and evidence of completion.

Social housing electrical safety checks after the November 2026 deadline, in one table
QuestionAnswerWhat to check today
Which deadline just passed?Checks before 1 November 2026 for covered social tenancies granted before 1 December 2025Every applicable home has evidence, not just an appointment
What must be checked?Fixed installations, plus equipment supplied under the social tenancyKeep installation reports and equipment records distinct
How often after that?No more than five years, or earlier if the report or record says soStore the actual next due date
What follows an unsatisfactory installation report?Required work within 28 days of inspection, or a shorter period specified in the reportAssign an owner and obtain completion evidence
What follows an unsafe equipment finding?Inform the tenant immediately for an occupied-tenancy periodic check; make safe or replace as soon as reasonably practicable, within 28 daysDo not put the warning in the routine correspondence queue

Sources for the table are regulation 3, regulation 3E, the 2025 equipment provisions and government guidance.

Who needs social housing electrical safety checks in England?

These requirements cover registered providers’ specified social housing tenancies in England, subject to exclusions. They are not a UK-wide deadline or a blanket rule for every building a facilities team manages. The 2025 regulations extend the existing rented-sector framework to social housing.

The government describes covered homes as those occupied as the tenant’s only or main residence with rent payable. Its scope guidance lists exclusions including long leases and shared ownership leases, student halls, hostels, refuges and care homes.

For social tenancies granted before 1 December 2025, the relevant duties commenced on 1 May 2026, with initial checks required before 1 November 2026. Those dates are stated in the commencement and transitional provisions. Do not describe November as the start of a new six-month grace period.

Communal corridors and stairwells are outside these particular regulations, according to the government’s supplementary guidance. That does not make communal electrics exempt from other safety duties. Keep the communal maintenance programme separate rather than treating a flat’s report as evidence for the whole block.

Is an EICR enough, or do supplied appliances need checking too?

An Electrical Installation Condition Report, usually called an EICR, addresses the installation. Social landlords also need records for electrical equipment they supply under the tenancy. The government guidance treats these as separate requirements.

The fixed installation includes wiring, sockets, light fittings, the consumer unit and permanently connected equipment such as showers and extractors. Supplied equipment can include a fridge, cooker or microwave. The qualified person determines the visual inspection, testing or combination needed for equipment. The government guidance on equipment checks explains the distinction. Do not reduce that requirement to a sticker on every appliance.

Equipment checks produce an In-service Inspection and Testing of Electrical Equipment record, or ISIT record. The equipment provisions require the results and, where equipment is safe for continued use, the next check date. They also require equipment information and records to reach the person inspecting the installation.

For your working register, use one property reference but separate fields for installation status, each supplied item’s status and outstanding actions. A satisfactory installation report should not hide an unchecked landlord-provided fridge. Conversely, the resident’s own microwave should not silently become a landlord-supplied asset.

What starts the remedial work and resident communication deadlines?

For installations, the inspection date starts the period for required remedial or investigative work, not the date somebody uploads the report. For unsafe supplied equipment identified at a periodic check, immediate resident notification is a separate duty from making it safe or replacing it. See regulation 3 and the equipment duties inserted in 2025.

Keep these clocks separate:

Remedial work and resident communication deadlines, by the event that starts them
EventRequired follow-through
Installation inspection completedGive each existing tenant the report within 28 days of inspection
Installation report requires workComplete required work within 28 days of inspection, or any shorter period specified
Installation remedial or investigative work completedObtain qualified-person confirmation; send it with the original report to the existing tenant and local housing authority within 28 days of completion
Periodic equipment check finds an item unsafeImmediately inform the tenant; make safe or replace as soon as reasonably practicable and no later than 28 days after the check
Existing tenant requests an equipment record in writingSupply it within 28 days of the request
Council requests records in writingSupply the installation report within seven days; equipment information and records also have a seven-day requirement

The installation timings come from regulation 3(3) to (6). The equipment timings come from regulations 3C and 3D, inserted by the 2025 instrument.

An electrician’s invoice proves a transaction, not necessarily that the required safety outcome was achieved. Ask for the qualified person’s confirmation and link it to the finding. If that confirmation identifies more work, do not close the case merely because the first visit happened.

For occupied homes checked near the end of October, November can therefore contain live repair and document-supply deadlines. That is why the post-deadline review matters now, rather than at the next five-year cycle.

Does every electrical fault give the landlord 28 days?

No. Twenty-eight days is not permission to leave an immediate danger unresolved. The installation report can specify a shorter period, and unsafe equipment must be addressed as soon as reasonably practicable. The government’s remedial-work guidance explains the requirements.

The guidance defines installation findings as C1, danger present; C2, potentially dangerous; C3, improvement recommended; and FI, further investigation required without delay. C1 and C2 require remedial work. FI requires investigation. C3 alone does not make an installation report unsatisfactory, according to the report guidance.

Do not ask a receptionist, resident or AI to assign those technical codes from a telephone description. Have the qualified electrician assess the condition. Your first-contact process should recognise reasons for urgent escalation without pretending to conduct an electrical inspection.

London Fire Brigade identifies scorch marks, flickering lights, hot plugs or sockets and unexplained circuit-breaker trips as possible warning signs. It advises getting concerns checked by a qualified electrician in its electrical safety guidance.

A resident reporting one of those signs after a satisfactory EICR still needs a response. A past report is not a diagnosis of tonight’s fault. For the broader distinction between receiving a hazard report and organising the response, see our out-of-hours repairs guide.

What should the team do when a tenant will not allow access?

Record the attempts, address the reason access failed and arrange a workable next step. The regulations provide an all-reasonable-steps protection for specified duties, not a rule that a fixed number of unanswered messages automatically proves compliance. See regulation 3(2A) and (2B).

The government guidance on access recommends keeping communications and other relevant safety evidence. It also explains that a landlord prevented from entering is not treated as having failed to take all reasonable steps solely because it has not brought legal proceedings.

Use a record that answers practical questions. Was the appointment confirmed? Did the resident understand the visit? Was the engineer unable to reach the consumer unit? Did the tenant need a different time or support to prepare? What did the landlord offer next?

A useful appointment message is:

We need to arrange an electrical safety visit at your home. Please reply with a suitable time, or tell us what would make access difficult. We will confirm the appointment and explain what the electrician needs to reach. If you are reporting a current electrical fault, tell us now so we can arrange the appropriate response separately.

That is a suggested communication, not a statutory notice. Escalate unresolved access cases to the responsible housing or compliance lead. Do not let an automated workflow threaten entry or decide the legal response.

How can teams handle electrical reports and appointment replies out of hours?

Use a first line that can distinguish an inspection booking from a current safety concern, then reach a person authorised to act. The comparisons below are workflow assessments, not measured vendor performance or legal compliance ratings.

Voicemail and a shared inbox

Best for: low-volume appointment replies where a team checks messages reliably and residents have a separate, staffed emergency route.

Email preserves what arrived, but an unmonitored inbox cannot respond to a resident who adds “the socket is hot” to a booking reply. Assign responsibility for reviewing each channel and transferring urgent reports.

Unlike an unattended inbox, Kreedl offers a round-the-clock first response across calls and messages; it still needs your escalation rules.

An on-call manager or electrician

Best for: portfolios with dependable cover and someone who can make informed decisions about the property and available contractors.

The direct conversation can resolve ambiguity quickly. The weakness to test is continuity when that person misses a call, changes shift or records the decision somewhere the daytime team cannot see.

Kreedl can provide first-line intake before escalating to your team, but it does not replace the electrician’s technical judgement.

A staffed answering service

Best for: teams that want human first contact and can give operators a clear script, live contacts and an agreed handover process.

Check the actual service. Can it distinguish a request for a report copy from an unsafe-equipment finding? Who confirms the on-call contact accepted the case? Where is that recorded?

Kreedl offers rule-bounded vendor dispatch and follow-up as well as answering; compare those capabilities with the specific answering service, not a generic call-centre label.

Where does Kreedl fit?

Kreedl fits the communication and coordination layer, not electrical certification. Its public product description covers answering phone, WhatsApp, SMS and email, working out urgency, dispatching vendors within agreed limits, escalating exceptions and following up to closure.

For this workflow, the useful outcome is that a resident’s late reply becomes an actionable case rather than a message waiting for office hours. The electrician should receive the fault description, location and access context. The responsible manager should receive exceptions outside the agreed boundaries.

Configure this deliberately. Confirm which systems receive the record, what the handover includes and who owns unresolved cases. Do not assume a statutory deadline calculator, certificate validation or automatic distribution to the council without testing and agreeing that workflow. Those are not claims made here.

What should a post-deadline checklist contain?

Start with missing evidence and unresolved danger, not the percentage of appointments booked. This is a recommended operational checklist, not an additional legal reporting requirement.

  • Reconcile the occupied-home list against completed installation inspections.
  • Check the next inspection date and every outstanding finding.
  • Reconcile supplied equipment against item-level records and replacement evidence.
  • Separate inaccessible homes from homes where nobody arranged a visit.
  • Give each exception a named owner, next action and review date.
  • Check installation reports reached existing tenants within the required period.
  • Check unsafe-equipment warnings were not queued as routine correspondence.
  • Match remedial work to qualified-person confirmation and required document delivery.
  • Check tonight’s escalation contacts, cover arrangements and contractor availability.
  • Review any missed deadline with the compliance lead rather than changing its recorded date.

Local councils may impose financial penalties of up to £40,000 for breaches of specified duties, according to the government’s enforcement guidance. That is a maximum, not an automatic fine for each missing appointment.

How do you know your electrical reporting line works?

Test whether a report reaches an accountable person with enough information to act, not merely whether someone answers. Use an agreed test environment or pre-briefed staff so a simulated hazard cannot trigger a real emergency response.

Run three scenarios: a tenant changing an inspection appointment, a resident reporting a hot socket at night, and a request for an equipment record. Label each as a test and prevent real contractor dispatch.

For each, inspect the record. Does it identify the home, report time and resident’s concern? Does the urgent scenario reach the agreed human? Does the appointment change reach the scheduling owner? Is the record request captured with its receipt date and delivery owner?

Then simulate an unavailable on-call contact. A successful first call is not enough if the case disappears when the first escalation fails. Agree the fallback and the review process before relying on it overnight.

When is Kreedl the wrong choice?

Kreedl is the wrong first investment if the missing piece is qualified electrical capacity, an accurate asset register or authority to approve urgent work. Answering more calls cannot supply those foundations.

It may also be unnecessary where a small portfolio already has reliable staffed cover and a clear shared record. And it cannot replace in-person support where residents need that to understand or participate in the inspection process.

Fix responsibility, access arrangements and contractor cover first. Then decide whether automation removes a specific communication gap.

What else do landlords ask about electrical safety checks?

Not automatically. The government guidance says a further inspection is not required where an inspection took place less than five years ago and the report requires no further investigative or remedial work. Check any earlier next-inspection date and resolve outstanding findings rather than relying on the report’s age alone.

No. The equipment provisions require checks at intervals of no more than five years, or sooner where the record requires. A qualified person determines the necessary visual inspection, testing or both. Do not describe this as a universal annual PAT requirement.

No. Existing tenants must receive the installation report within 28 days of inspection under regulation 3(3)(b). Equipment records have a different rule for existing tenants: supply them within 28 days of a written request under regulation 3D.

For an unsafe item identified during a periodic equipment check in an occupied tenancy, regulation 3C requires the tenant to be informed immediately. Treat that notification as separate from arranging repair or replacement. A routine Monday correspondence queue is not an immediate-warning process.

The draft 2026 amendment regulations show a proposed commencement of 30 November 2026 and are labelled draft, not made legislation, on the source checked for this guide. They do not propose replacing the before-1-November inspection deadline. Do not treat a draft’s proposed start date as a compliance extension.

Which sources support this guide?

These are the primary legal, government, fire-service and product sources checked on 8 November 2026.

  1. Electrical Safety Standards regulations, regulation 3 (installation inspections, reports, remedial work and reasonable steps)
  2. Regulation 3E (the transitional deadline for older social tenancies)
  3. 2025 extension regulations, SI 2025/1043 (scope, commencement, equipment checks and records)
  4. GOV.UK electrical safety guidance (practical explanation and exclusions)
  5. London Fire Brigade electrical safety guidance (warning signs and qualified-electrician advice)
  6. Draft 2026 amendment regulations (proposed changes, not treated as current law)
  7. Kreedl product page and live test page (product capabilities and demonstration)

This article is general information, not legal advice, correct as of 8 November 2026. Check current legislation and guidance before changing your procedures.

Want to test the handover before the next night report?

Book a demo to discuss your resident intake and escalation process. Or try a live test call before deciding whether Kreedl belongs in it. A demo tests the conversation, not the electrical safety of a home.

Want to see it on your buildings?

Book a demo to see how Kreedl answers a night report, triages it against your rules and logs every step. Or call the agent yourself first.

Try it live